Hi,
I have replace the case/shell of my Thinkpad T20.
This meant to take all parts out and put them together at
a later stage (incl motherboard/ cpu fan ect).
I did it a couple of times and it does all fit and look good.
The trouble is that my system won't start up.
After pressing the power button the system will 3 PEEP 3 times (short peeps) and shuts down after wards.
Does anybody know what these peeps mean?
Is there any part that might have died during this operation (eg cpu fan / sub card)?
Many thanks.
CF
Take a look at our
ThinkPads.com HOME PAGE
For those who might want to contribute to the blog, start here: Editors Alley Topic
Then contact Bill with a Private Message
ThinkPads.com HOME PAGE
For those who might want to contribute to the blog, start here: Editors Alley Topic
Then contact Bill with a Private Message
Thinkpad T20 - put together - doesn't start up - strange
-
cyberfilmmaker
- Freshman Member
- Posts: 66
- Joined: Thu May 05, 2005 5:08 pm
- Location: London/ UK
Thinkpad T20 - put together - doesn't start up - strange
Last edited by cyberfilmmaker on Fri Mar 17, 2006 7:59 pm, edited 1 time in total.
-
cyberfilmmaker
- Freshman Member
- Posts: 66
- Joined: Thu May 05, 2005 5:08 pm
- Location: London/ UK
Thinkpad t20 error peep codes found - bizarre symptom still
Hi ,
I just found the error PEEP codes :
http://www-307.ibm.com/pc/support/site. ... IGR-4K7KB7
Three short beeps 3 times is either DIMM or MOTHERBOARD
I replaced the memory DIMM. Now the peeps are gone.
BIZARRE SYPTOMS:
1]
When using the power supply, battery light is on (indicating fully charged battery),I press power button, hard disk light
goes on for a sec , but than they entire system shuts down including battery light. Pressing power nothing happens.
2]
When using battery power, pressing the power button the hard disk light goes on and off again. I can press the power button to get the same result.
I managed once to get the WINDOWS start up screen (on BATTERY/ F1 key)...after a couple of seconds it shut down again.
Can anybody still shed some light onto this. Is this a symptom that some specific part is broken (eg cpu fan)?
many thanks,
CF
I just found the error PEEP codes :
http://www-307.ibm.com/pc/support/site. ... IGR-4K7KB7
Three short beeps 3 times is either DIMM or MOTHERBOARD
I replaced the memory DIMM. Now the peeps are gone.
BIZARRE SYPTOMS:
1]
When using the power supply, battery light is on (indicating fully charged battery),I press power button, hard disk light
goes on for a sec , but than they entire system shuts down including battery light. Pressing power nothing happens.
2]
When using battery power, pressing the power button the hard disk light goes on and off again. I can press the power button to get the same result.
I managed once to get the WINDOWS start up screen (on BATTERY/ F1 key)...after a couple of seconds it shut down again.
Can anybody still shed some light onto this. Is this a symptom that some specific part is broken (eg cpu fan)?
many thanks,
CF
-
tfflivemb2
- Moderator Emeritus

- Posts: 5605
- Joined: Thu Sep 01, 2005 1:17 pm
- Location: Wisconsin
- Contact:
-
cyberfilmmaker
- Freshman Member
- Posts: 66
- Joined: Thu May 05, 2005 5:08 pm
- Location: London/ UK
problem solved - different hard disk bays T23 T20
Hi tfflivemb2,
many thanks for your reply.
The solution was as bizarre as the symptom!
It seems my new case/shell is from a T23 and there are different disk trays (T20 vs T23 / IBM MANUAL DOCUMENT 62p9631 PAGE:116).
I needed to use my old T20
Hard disk bay otherwise the hard disk malfunctions and the system would shut down. It think it is the way the isolation at the bottom of these trays are designed.
Well it works now all fine.
Back from the twilight zone

All the best
CF
many thanks for your reply.
The solution was as bizarre as the symptom!
It seems my new case/shell is from a T23 and there are different disk trays (T20 vs T23 / IBM MANUAL DOCUMENT 62p9631 PAGE:116).
I needed to use my old T20
Hard disk bay otherwise the hard disk malfunctions and the system would shut down. It think it is the way the isolation at the bottom of these trays are designed.
Well it works now all fine.
Back from the twilight zone
All the best
CF
-
- Similar Topics
- Replies
- Views
- Last post
-
-
[WTB] Cable+invertor KIT to put a hv150ux2-100 screen in a T60/T61
by stryker86 » Sun Feb 22, 2026 3:53 am » in Marketplace - Forum Members only - 2 Replies
- 2248 Views
-
Last post by RealBlackStuff
Thu Mar 05, 2026 1:35 pm
-
-
-
[WTB] Thinkpad x61 battery (battery life doesn't matter as long as it works)
by Redaa » Sun Jan 25, 2026 6:08 am » in Marketplace - Forum Members only - 2 Replies
- 5391 Views
-
Last post by Redaa
Sun Jan 25, 2026 6:27 am
-
-
- 2 Replies
- 19084 Views
-
Last post by mvaudio
Sun Nov 02, 2025 9:57 am
-
-
X61s screen backlight doesn't work. Faulty mobo?
by huohuo » Tue Mar 03, 2026 6:35 pm » in Thinkpad X60/X61 Series incl. Tablets - 4 Replies
- 3531 Views
-
Last post by huohuo
Sat Apr 04, 2026 3:43 pm
-
Who is online
Users browsing this forum: No registered users and 88 guests



