[SOLVED] T30 Shows VGA Resolution Only

Message

singbad · #1 Post by **singbad** » Sat Apr 23, 2011 10:47 am

Hi,
I have a T30 that shows VGA resolution on startup, during BIOS setup and also after the system has booted. Everything is displayed about twice as big, both on the LCD and on an external Monitor. I tried everything but I couldn't change it.

Could there be something wrong with the graphics chip?

Best regards,
singbad

jronald · #2 Post by **jronald** » Sat Apr 23, 2011 5:08 pm

Not likely.
I would reload the driver and see where it gets you.

Ron

singbad · #3 Post by **singbad** » Sun Apr 24, 2011 5:26 pm

I found out it's the LCD. I tried to replace the original LCD by a Hyundai HT14X14 which probably has this double channel thing.

Can I set the ATI Mobility Radeon 7500 to double-channel mode? I'd have to hack the BIOS, right?

Best regards,
singbad

singbad · #4 Post by **singbad** » Tue Apr 26, 2011 7:46 pm

SOLVED: It's not the LCD, it's the SXGA cable I was using.
http://forums.thinkpads.com/~thinkpad/f ... 54&start=0

Thanks for your replies!

singbad

[SOLVED] T30 Shows VGA Resolution Only

[SOLVED] T30 Shows VGA Resolution Only

Re: T30 Shows VGA Resolution Only

Re: T30 Shows VGA Resolution Only

SOLVED: T30 Shows VGA Resolution Only

Who is online