WTB: Modified LCD cable W/Bluetooth or standard one I have modified (91P6985) + Inverters

[ScottSpeed]

Hello everyone! I'm currently looking to get the modified LCD cable so I can put the BoeHydis (HV150UX2-100) display in my T60. I had one found on ebay but someone else bought it literally right before I went to sit down and buy it this morning.

I'm sure that's going to be a hard find so I will also look at stock cables that I can have modified. I believe there are a couple part numbers but I am wanting the one with bluetooth (91P6985) Other PN may be 91P6984?

Thank you so very much for taking the time to read this!
Kind regards!
Lincoln

(EDIT) I am also looking for any of the listed usable inverters so I can complete the upgrade. (copied from "The Board Room" website):
42T0078 / 42T0079 made by Hitachi, also has marking INVC753
41W1012 / 39T5658 made by Hitachi, also has marking INVC753
13R1014 / 13R1015 made by Sumida

[RealBlackStuff]

I don't remember ever having seen one of those LCD-cables as were listed in the HMM manual: 91P6985 (with B/T) or 91P6983 (without B/T).

AFAIK they always used these LCD-cables in the 15" non-widescreen T60: 91P6970 (with B/T) or 91P6950 (without B/T).
I also have these mentioned on my LED-mod website: https://theboardroom.info/led_mods4.html#approved

For some unknown reason these cables were never listed/updated in the HMM.

However, I noticed this (91P6985 with B/T) cable: https://www.impactcomputers.com/91p6985 ... idx=130215
They are a reliable outfit.

[ScottSpeed]

Ahh ok awesome thanks!! I will check out that link you posted. So I completely forgot to mention earlier that I was needing the inverter as well. Those seem to be even harder to find or I'm just not looking in the correct place?

Thank you so much for all the help!

[ScottSpeed]

So apparently I just needed to look a little bit harder as I was able to find everything I need. So thanks again for helping out!!

I'll get back on here if I run into any issues.

Kind regards
Lincoln