T-23 and maximum memory

Message

tp23 · #1 Post by **tp23** » Sat Feb 11, 2006 5:40 am

I just upgraded my T23 - 256meg to 1 gig of PC133 memory because I wanted to eliminate having to use a pagefile that suffers from a slow hard drive. Both the new 16 chip 512meg modules I bought are identical but when I use both in my T23, screen refreshes are real slow and it seems to take forever for applications to start. Aside from the slow stock hard drive, this T23 was real snappy when I used 2- 128meg modules.
I tried every possible combination of memory insertion but the result is the same, faster performance when using just one 512meg module. I have the most current bios installed too.

djpharoah · #2 Post by **djpharoah** » Sat Feb 11, 2006 11:14 am

sounds like those ram modules might be PC100 instead of PC133.

-dj

betabily · #3 Post by **betabily** » Sun Feb 12, 2006 3:32 pm

The memory is correct, ran memtest for TP23 on both modules, memtest reports numerous errors in test #1 on one module, already got an RMA#. The good module has been looping all tests for 3 hours without error.

"Thats what friends are good for"

tp23 · #4 Post by **tp23** » Tue Feb 21, 2006 7:38 pm

UPDATE! I replaced the seemingly defective PC133 ram module and after a few minutes, my system really slowed down, just like as before.
Now I've heard that there are two types of memory available for a t-23, low and high density. Mine have 8 chips on each side for a total of 16 chips and I have heard that this is a high density configuration. I also heard that there are also low density memory modules with 4 chips on each side. Yet I have not been able to determine whether you need low or high density ram for 1gig on a t-23. As it stands, my t23 runs fine on a single 512 16 chip module but doesnt seem to like 2-512 16 chip modules.

Who knows what the correct configuration for t23 memory?

Nolonemo · #5 Post by **Nolonemo** » Wed Feb 22, 2006 1:58 pm

Well, I just got a PC133 512MB stick which has an "IBM Approval" sticker on it, FRU# 19K4657 and 8 chips per side (16 chips total), so I don't see why 2 of them would pose a problem.

I wonder if there's some other difference between the sticks, synch v asynch, for example (I don't even know if PC133 SODIMMS come in these flavors, I'm just throwing out an idea)

jwschmid · #6 Post by **jwschmid** » Wed Feb 22, 2006 5:05 pm

Will these PC100 512mb low density's work in a T20 2647-9EU

Thanks,

John

tp23 · #7 Post by **tp23** » Wed Feb 22, 2006 10:07 pm

Either of my 512 PC133 work well in either of the two memory slots, both sticks are identical, but just the same I'm going to try the paper over the edge connector trick on my T23 memory slots, maybe they just need cleaned.

T-23 and maximum memory

T-23 and maximum memory

Who is online